Catégories
Documents disponibles dans cette catégorie (1090)
![Tris disponibles](./images/orderby_az.gif)
article/chapitre/communication
article/chapitre/communication
W. Stewart ; K. Smith | 1987article/chapitre/communication
article/chapitre/communication
K. Ichimiya ; N. Hosaka | 1992Présentation des résultats expérimentaux du transfert de chaleur provoqué par trois jets : pour un écoulement incident laminaire d'une part et pour un écoulement turbulent d'autre part.article/chapitre/communication
S. Joshi ; A. Bergles | 1980article/chapitre/communication
W. Qi ; Y. Shimming | 1999article/chapitre/communication
I. Welling | 2000This article describes an experimental study of natural convection around a horizontal square plate and a vertical cylinder, and provides data for the velocity and temperature profiles around representative heat sources of high heating capacity.[...]article/chapitre/communication
S. Ishigai ; E. Nishikawa | 1975article/chapitre/communication
Two low-aspects-ratio trapezoidal test section geometries, simulating the trailing edge cooling cavities of turbine blades, roughened with seven different turbulator geometries, were tested for heat transfer and pressure variations. The test sec[...]article/chapitre/communication
P. Carrica ; S. Leonardi ; A. Clausse | 1995An experimental study is conducted to measure the transient characteristics of the local boiling process close to the heated wall. Nucleate and film boiling two-phase parameters were measured for power oscillations in a small horizontal heater i[...]article/chapitre/communication
T. Aihara ; K. Yamamoto ; AL Et | 1997Heat transfer characteristics of a turbulent, dilute air-solids suspension flow in thermally developing/developed regions were experimentally studied, using a uniformly heated, horizontal 54.5 mm-ID pipe and 43-mu m-diameter glass beads. The loc[...]article/chapitre/communication
N. Seki ; S. Fukusako ; K. Torikoshi | 1978article/chapitre/communication
M. Krane ; F. Incropera | 1997Experiments were performed with binary metal alloys to validate a continuum mixture model for alloy solidification. Ingots of two compositions, Pb-20%Sn and Pb-40%Sn, were cast in a permanent mold, and the solidification process was simulated Te[...]article/chapitre/communication
M. Yamada ; S. Fukusako | 1997Experiments on the melting of a vertical ice layer immersed in immiscible liquid yielded quantitative results both for the timewise evolution of the melting front and the heat transfer. Vegetable oil, which was contained in a rectangular vessel,[...]article/chapitre/communication
L. Ortiz ; J. Gonzalez | 1999Spray cooling is a promising technique for the removal of high heat fluxes (SSHHF) under steady statein many practical applications. This article reports on experimental results which quantify the effects that mass flow rate, surface roughness, [...]